摘要
这是用于生产大连佳能打印机的一个固定板零件的模具设计,通过各方面的比较,确定采用级进模的形式,模具的闭合高度为215mm,步距为66mm,在这套模具的设计中重点设计了冲孔、切边、去毛刺这几道工序及其凸模和凹模的尺寸和结构,最终设计采用10个工位的级进模将零件完整地冲出,达到设计的要求。
关键词: 级进模 毛刺 冲孔 闭合高度 步距
Abstract
The mold is making a retainer of Dalian Canon print . Compare with
many cases .I use the progressive draw . The shut height of the mold is
215mm., and the pitch is 66mm. According to this mold . I desiged piercing , trimming, burr-off, punch and die . At last ,the mold has 10 positions to make the retainer ,and the mold is ok to us.
Keywords: progressive draw burr piercing shut height pitch
目 录
第一章 产品工艺分析 1
§1-1零件图工艺分析 1
§1-2工艺方案的确定 4
§1-3级进模的特点 5
§1-4模具结构形式的确定 6
§1-5目标值的确定 8
§1-6申请接刀 8
第二章 排样图的设计及其有关说明 11
§2-1主要零件的介绍 11
§2-2排样图的设计 14
§2-3研讨方案 20
§2-4材料利用率 21
第三章 模具结构分析和设计 22
§3-1各块模板的作用及材料 22
§3-2组件结构 24
§3-3凸模、凹模设计和装配 28
§3-4模具的设计和装配 32
第四章 工艺计算和工艺参数
41
§4-1主要工艺参数的计算 41
§4-2冲压设备的选择 43
§4-3确定压力中心 45
§4-4凸模强度校核 45
五 附录 46
下上型部件代号解释表 46
上下型装配图说明 47
3) 模具标准件清单 48
4) 工序卡 51
六 设计体会 52
参考文献 53