论文59页,23000余字,CAD图16张
摘 要
本毕业设计论文以阐述手机塑料外壳注射模设计过程为主线。该模具设计采用一模两腔的布置;双分型面分型;剪切浇口浇注形式;四导柱对称不等直径分布导向定位方式;使用推杆推出脱模机构;并采用了整体式型腔、型芯,使结构简化、可行;利用弹簧抽芯机构实现模具的侧向抽芯。最后结合模具的标准组合结构和标准零件的选用,完成了整套模具的装配。并对有关技术规范进行全面校核,确保所设计的模具能正确安装在所选的注射机上并应用于生产。
关键词:手机外壳;一模两腔;双分型面;剪切浇口;四导柱;弹簧抽芯; CAD
Abstract
This paper mainly discusses the injection design process of a cover of mobile phone. To make the processing technology simple and available,
The mould uses a mould with two cavities , two parting surfaces, shear gate Besides, four symmetry but not equal-diameter guide pillars for orienting, handspike for pulling off the injection parts. and combined cavities and cores . Besides, spring coil is used in order to realize the side- loose core. In the end the correlative technical standards are checked up in order to ensure that the mould can be properly fixed in the injecting machine and can be put into use .
Key words: cover of mobile phone ; mould with two cavities ; double parting surface ; shear gate, four guide pillar; spring for core-loosing;CAD
目 录
第一章 塑件的成形工艺性分析? 1
第二章 模具结构形式的拟定??? 5
第三章 注塑机型号的确定 7
第四章 分型面位置的确定 11
第五章 浇注系统的形式和浇口的设计 14
第六章 模架的确定和标准件的选用?? 26
第七章 合模导向机构的设计??? 29
第八章 脱模推出机构的设计??? 31
第九章 侧向分型机构的设计??? 33
第十章 成型零件的设计?? 38
第十一章 排溢系统的设计 49
第十二章 冷却回路的设计 50
第十三章 模具材料的选择 52
第十四章 模具的工作过程 55
第十五章 模具的试模与修模??? 56
设计总结? 58
参考文献? 59